So Glad To Be Back

Every since I saw this card by Linda Duke on Linda's Works Of The Heart blog, I have wanted to do something similar for months. Well, I ordered the Poppy Patch set from Flourishes and there it sat too. Last week I visited Phree at Ink Stain Survivor (she hadn't been around in a while) , saw her 'Shirley Poppies' card and the came on! So now you know where my ideas come from and probably why I only get one or two cards done in a week. Ha! I think I even have some of these flowers in my yard. I never knew there were Shirley Poppies! I built this card from the background up to allow for the punched border first and then all of the materials inside of it.

Card Fold:
1. I cut a bigger card than I would have because punching the border causes a loss of about 1/4" on length and a little less on the width after punching the border. I cut a 5.5"x11" piece of paper. I have 5.5 square envelopes, and needed a little bit smaller card.

2. Using Fiskars Apron Lace Border Punch, I punched the right end, or center piece, of the border first. I knew by looking at my pre-punched sample that I needed to have one complete half-circle on the right and the left ends for the "going around the corner" to work. *After the center part is done I work totally from the back side of the punch (It's turned upside down so you can see the bottom edge of the cardstock to make sure you punch in a straight line. You will know once you try it what I mean.)

3. It was folded so the one punched edge is even with the back right side of the card.

4. I turned the punch to do the sides, starting to create the rounded corner first. I've tried to show that below. If you click on the image below you can see that I've made the second side transparent so you can see what you will be looking at from the back of the punch when you do the left side. Of course you have to imagine the card is everything to your right. If this is confusing for you try either of these two Border Punch Video 1 or this Border Punch Video 2 that might help.

4. Then I measured the inside of the card height and width. I used Neenah Classic Laid Millstone cardstock.

5. For the bottom half I used a piece of double sided sticky sheet half the size of the Millstone, and with tan colored mesh on top.

6. I applied a light blue ribbon from Michael's $1 bin as a seam between the top and the bottom.

7. I applied USArt Quest Mica D'Lites Gold over that for the sticky areas not covered by the mesh.

Ocean View Image:
1. The largest Spellbinders Labels One die was used with Neenah Classic Laid Solar White cardstock in my Cuttlebug.

2. I didn't have any scape stamps for the images and could never make up my mind on which ones to get, so I used Linda's card as a guide and did the rest with Twinkling H2O's and a Niji waterbrush. I also used a little bit of the Gold mica and some Baby Pink Flower Soft.

3. Anna Griffin Cream Designer Paper was used for the outside frame. I put it through the Cuttlebug to emboss only and then trimmed around the double embossed edge.

Flower Images:
1. Stamped with Brilliance Galaxy Gold on Neenah Solar White cardstock and heat set to dry ink.

2. Painted with Twinkling H2O's.

3. Ivory Flower Soft applied to the centers and then a little Twinkling H2O Yellow Drop and a tad of Rangers Stickles Yellow.

4. When dry the images were cut out.

5. The flowers and leaves were mounted with glue and 3D Glue Dots.

6. A light blue ribbon was tied around the flowers.

7. The Sand Dollar is from Fanciful Inc. online.

The colors are really much softer in real life, but this is how the camera saw it to day! Thanks for stopping by 'the blog' to look and share. Hope to be back soon!

 

 Shirley